Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



2. INSTALL NO. 1 ECM BRACKET
  1. Install the No. 1 ECM bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



3. INSTALL ECM
  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 4 connectors.



4. INSTALL TRANSMISSION CONTROL ECU (for Automatic Transmission)
  1. Install the transmission control ECU with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 3 connectors.



5. INSTALL TURBO MOTOR DRIVER
  1. Install the turbo motor driver with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



6. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


B278068E01
  1. Attach the 2 hinges to install the glove compartment door.
    Text in Illustration 
    *1
    Hinge



    B278069E01
  1. While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
    Text in Illustration 
    *1
    Stopper



7. PERFORM REGISTRATION
  1. Perform registration (Click here).

    HINT:
    Only perform registration when the ECM is replaced, either by itself or in any of the following combinations.
    1. ECM and Fuel Supply Pump
    2. ECM and Diesel Throttle Body Assembly
    3. ECM and Injector Assembly
    4. ECM and Engine Assembly



8. START ENGINE
  1. When replacing the ECM, start the engine to initialize the new ECM (Click here).