Home › ENGINE · 2KD-FTV › EMISSION CONTROL › VACUUM SWITCHING VALVE

VACUUM SWITCHING VALVE > INSPECTION

for Preparation Click here



1. INSPECT VACUUM SWITCHING VALVE (for EGR Cut)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    37 to 44 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    1 MΩ or higher

    If the result is not as specified, replace the vacuum switching valve.



  1. Check the operation of the vacuum switching valve.



      A151248E06
    1. Attach a vacuum pump to port E and check that air does not flow from the filter to port E.
      Text in Illustration 
      *1
      Port E
      *2
      Filter



    2. A151249E05
    3. Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Filter

    4. Attach a vacuum pump to port E and check that air flows from the filter to port E.
      If the result is not as specified, replace the vacuum switching valve.