REAR DOOR > ADJUSTMENT |
![]() |
| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH |
Check that the clearance measurements of areas A to M are within the standard ranges.

| Area | Specified Condition | Area | Specified Condition |
| A | 3.5 to 6.5 mm (0.139 to 0.256 in.) | B | 0.5 to 3.5 mm (0.0197 to 0.138 in.) |
| C | 3.5 to 6.5 mm (0.139 to 0.256 in.) | D | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| E | 3.5 to 6.5 mm (0.139 to 0.256 in.) | F | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| G | 3.0 to 6.0 mm (0.118 to 0.236 in.) | H | -0.7 to 2.3 mm (-0.0276 to 0.0906 in.) |
| I | 3.0 to 6.0 mm (0.118 to 0.236 in.) | J | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| K | 4.0 to 7.0 mm (0.158 to 0.277 in.) | L | 7.4 to 10.4 mm (0.291 to 0.409 in.) |
| M | 15.2 to 18.2 mm (0.598 to 0.717 in.) | - | - |
| 2. ADJUST REAR DOOR PANEL SUB-ASSEMBLY LH |
![]() |
Loosen the hinge bolts on the body and adjust the door position.
Tighten the hinge bolts on the body after the adjustment.
![]() |
Loosen the hinge bolts on the door and adjust the door position.
Tighten the hinge bolts on the door after the adjustment.
![]() |
Using a T30 "TORX" socket, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Using a T30 "TORX" socket, tighten the striker mounting screws after the adjustment.