Home › BODY › ENGINE HOOD / DOOR › BACK DOOR

BACK DOOR > ADJUSTMENT

for Preparation Click here


HINT:

  1. B276679E01
    Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).

Text in Illustration 
*1
Centering Bolt
*2
Standard Bolt


1. INSPECT BACK DOOR PANEL SUB-ASSEMBLY


  1. Check that the clearance measurements of areas A to G are within the standard ranges.


    B278136E01


    Standard:

    Area
    Specified Condition
    Area
    Specified Condition
    A
    7.0 to 10.0 mm (0.276 to 0.394 in.)
    B
    -0.4 to 2.6 mm (-0.0157 to 0.102 in.)
    C
    6.5 to 9.5 mm (0.256 to 0.374 in.)
    D
    -0.3 to 2.7 mm (-0.0118 to 0.106 in.)
    E
    4.1 to 7.1 mm (0.161 to 0.280 in.)
    F
    -1.4 to 1.6 mm (-0.0551 to 0.0630 in.)
    G (Reference)
    6.5 to 9.5 mm (0.256 to 0.374 in.)
    -
    -



2. ADJUST BACK DOOR PANEL SUB-ASSEMBLY


    B278137
  1. Loosen the hinge bolts on the body.

  1. Adjust the back door panel by moving it up and down and left and right so that the clearance measurements are within the specified ranges.

  1. Tighten the hinge bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 13 ft.*lbf }



    B278138
  1. Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

  1. Tighten the striker mounting screws after the adjustment.

    Torque:
    18 N*m{ 178 kgf*cm , 13 ft.*lbf }