Home › TRANSMISSION · A343F AUTOMATIC TRANSMISSION › SHIFT LEVER

SHIFT LEVER > INSPECTION

for Preparation Click here



1. INSPECT SHIFT LOCK CONTROL ECU


C113154E21
  1. Measure the voltage and resistance according to the value(s) in the table below.

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard Voltage and Resistance:
    Tester Connection
    Condition
    Specified Condition
    G37-6 (ACC) - G37-8 (E)
    Ignition switch ON
    10 to 14 V
    Ignition switch ACC
    10 to 14 V
    Ignition switch off
    Below 1 V
    G37-7 (STP) - G37-8 (E)
    Brake pedal depressed
    10 to 14 V
    Brake pedal released
    Below 1 V
    G37-12 (KLS+) - G37-8 (E)
    1. Ignition switch ACC and shift lever in P
    Below 1 V
    2. Ignition switch ACC and shift lever not in P (Within approx. 1 second)
    7.5 to 11 V
    3. Ignition switch ACC and shift lever not in P (After approx. 2 seconds)
    6 to 9 V
    G37-1 (IG) - G37-8 (E)
    Ignition switch ON
    10 to 14 V
    Ignition switch off
    Below 1 V
    G37-8 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component with harness connected
    (Shift Lock Control ECU)
    If the result is not as specified, replace the transmission floor shift assembly.