Home › BODY › EXTERIOR › ROOF RACK

ROOF RACK > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL ROOF RACK ASSEMBLY LH

HINT:
When installing the roof rack, heat the vehicle body and roof rack leg cushion using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Roof Rack Leg Cushion
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or roof rack leg cushion excessively.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.

  1. When reusing a bolt:

    1. Clean the threads of the bolt with non-residue solvent.

    2. Apply adhesive to the threads of the bolt.

      Adhesive:
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.

  1. Install the roof rack assembly.

    1. Using a heat light, heat the vehicle body and roof rack leg cushion.

    2. Remove the peeling papers from the face of each roof rack leg cushion.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Install the roof rack with the 6 bolts.

      Torque:
      9.4 N*m{ 96 kgf*cm , 83 in.*lbf }



2. INSTALL FRONT ROOF RACK LEG COVER LH
  1. Attach the 4 claws to install the front roof rack leg cover.



3. INSTALL REAR ROOF RACK LEG COVER LH
  1. Attach the 4 claws to install the rear roof rack leg cover.



4. INSTALL CENTER ROOF RACK LEG COVER LH
  1. Attach the 2 claws to install the center roof rack leg cover.