SIDE MOULDING (for Rear Door) > INSTALLATION |
| 1. INSTALL REAR DOOR OUTSIDE MOULDING LH |
Install 5 new clips to the rear door outside moulding.
Attach the 5 clips to install the rear door outside moulding.
Install a nose piece to an air riveter or hand riveter.
Insert the mandrel part of a new rivet into the nose piece.
![]() |
Using the riveter, install the 3 rivets as shown in the illustration.
![]() |
| *1 | Riveter |
| *2 | Mandrel |
| *a | INCORRECT |
| *b | CORRECT |
![]() |
| *1 | Riveter |
| *a | INCORRECT |
| *b | CORRECT |
![]() |
| *1 | Riveter |
| *a | INCORRECT |
| *b | CORRECT |
| 2. INSTALL REAR DOOR SERVICE HOLE COVER LH |
Apply new butyl tape to the rear door panel.
![]() |
Pass the rear door inside locking cable, rear door lock remote control cable and wire harness through a new rear door service hole cover, and then attach the rear door service hole cover using the reference points on the rear door panel.
| *a | Reference Point |
| 3. INSTALL REAR DOOR NO. 2 TRIM BRACKET |
Install the rear door No. 2 trim bracket with the 2 screws.
| 4. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH |
![]() |
Connect the rear door inside locking cable and rear door lock remote control cable to the rear door inside handle.
Attach the 2 guides as indicated by the arrow in the illustration, and then attach the claw to install the rear door inside handle.
| 5. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
Attach the 10 clips to install the rear door trim board.
Install the screw.
| 6. INSTALL DOOR PULL HANDLE |
Install the door pull handle with the screw.
| 7. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL |
Connect the connector.
Attach the 2 claws and 2 clips to install the rear power window regulator switch assembly with rear door armrest base panel.