Home › BODY › EXTERIOR › SIDE MOULDING (for Front Side)

SIDE MOULDING (for Front Side) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT NO. 1 WHEEL OPENING EXTENSION PAD

HINT:
When installing the front No. 1 wheel opening extension pad, heat the front wheel opening extension using a heat light.

Standard:
Item
Temperature
Front Wheel Opening Extension
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the front wheel opening extension excessively.

  1. Clean the front wheel opening extension surface.

    1. Using a heat light, heat the front wheel opening extension surface.

    2. Remove the double-sided tape from the front wheel opening extension.

    3. Wipe off any tape adhesive residue with cleaner.



    B277906
  1. Install a new front No. 1 wheel opening extension pad.

    1. Remove the peeling paper from the face of a new front No. 1 wheel opening extension pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the front No. 1 wheel opening extension pad.



2. INSTALL FRONT NO. 1 WHEEL OPENING EXTENSION PAD

HINT:
When installing the front No. 1 wheel opening extension pad, heat the front wheel opening extension using a heat light.

Standard:
Item
Temperature
Front Wheel Opening Extension
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the front wheel opening extension excessively.

  1. Clean the front wheel opening extension surface.

    1. Using a heat light, heat the front wheel opening extension surface.

    2. Remove the double-sided tape from the front wheel opening extension.

    3. Wipe off any tape adhesive residue with cleaner.



    B277910
  1. Install a new front No. 1 wheel opening extension pad.

    1. Remove the peeling paper from the face of a new front No. 1 wheel opening extension pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the front No. 1 wheel opening extension pad.