Home › BODY › EXTERIOR › SIDE MOULDING (for Rear Side)

SIDE MOULDING (for Rear Side) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR NO. 1 WHEEL OPENING EXTENSION PAD

HINT:
When installing the rear No. 1 wheel opening extension pad, heat the rear No. 1 wheel opening extension using a heat light.

Standard:
Item
Temperature
Rear No. 1 Wheel Opening Extension
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the rear No. 1 wheel opening extension excessively.

  1. Clean the rear No. 1 wheel opening extension surface.

    1. Using a heat light, heat the rear No. 1 wheel opening extension surface.

    2. Remove the double-sided tape from the rear No. 1 wheel opening extension.

    3. Wipe off any tape adhesive residue with cleaner.



    B277909
  1. Install a new rear No. 1 wheel opening extension pad.

    1. Remove the peeling paper from the face of a new rear No. 1 wheel opening extension pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear No. 1 wheel opening extension pad.



2. INSTALL REAR NO. 1 WHEEL OPENING EXTENSION PAD

HINT:
When installing the rear No. 1 wheel opening extension pad, heat the rear No. 2 wheel opening extension using a heat light.

Standard:
Item
Temperature
Rear No. 2 Wheel Opening Extension
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the rear No. 2 wheel opening extension excessively.

  1. Clean the rear No. 2 wheel opening extension surface.

    1. Using a heat light, heat the rear No. 2 wheel opening extension surface.

    2. Remove the double-sided tape from the rear No. 2 wheel opening extension.

    3. Wipe off any tape adhesive residue with cleaner.



    B277908
  1. Install a new rear No. 1 wheel opening extension pad.

    1. Remove the peeling paper from the face of a new rear No. 1 wheel opening extension pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear No. 1 wheel opening extension pad.