Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the supplemental restraint system.



2. REMOVE REAR SEAT ASSEMBLY
  1. Remove the rear seat assembly (Click here).



3. REMOVE REAR DOOR SCUFF PLATE LH


B276927E01
  1. Put protective tape around the rear door scuff plate.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 claws and 2 clips and remove the rear door scuff plate.



4. REMOVE REAR DOOR OPENING TRIM LH


B276955
  1. Remove the rear door opening trim weatherstrip.



5. REMOVE BACK DOOR SCUFF PLATE


B276933
  1. Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.



6. REMOVE QUARTER TRIM JACK COVER SUB-ASSEMBLY


7. REMOVE QUARTER INSIDE TRIM BOARD LH


B277799
  1. Detach the 2 claws and remove the outer lap belt anchor cover.

    HINT:
    Use the same procedure for both outer lap belt anchor covers.



    B277800
  1. Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.



    B277801
  1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.

  1. Using a clip remover, remove the clip.

  1. Detach the 7 claws and 10 clips.



  1. Disconnect the power point socket connector and remove the quarter inside trim board.


    B276940



8. REMOVE REAR AIRBAG SENSOR LH


    B214756
  1. Remove the bolt and rear airbag sensor.

  1. Disconnect the connector.