Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 5L-E ENGINE CONTROL SYSTEM

5L-E ENGINE CONTROL SYSTEM > SERVICE DATA



Venturi (for Throttle Control Motor) 
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
18 to 22 Ω
2 - 3
18 to 22 Ω
4 - 5
18 to 22 Ω
5 - 6
18 to 22 Ω

Venturi (for Throttle Open Switch) 
Tester Connection
Condition
Specified Condition
1 - 2
Fully open
Below 1 Ω
1 - 2
Fully close
10 kΩ or higher

Crankshaft position sensor 
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
22 to 28 Ω

Engine coolant temperature sensor 
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
2.32 to 2.59 Ω
1 - 2
80°C (176°F)
0.310 to 0.326 Ω

Intake air temperature sensor 
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
2.09 to 2.81 Ω

Integration relay 
Tester Connection
Condition
Specified Condition
1J-4 - Body ground
Ignition switch ON
10 to 14 V

Manifold absolute pressure sensor (Wire Harness Side) 
Tester Connection
Condition
Specified Condition
M3-3 (VC (+)) - M3-1 (E (-))
Ignition switch ON
4.75 to 5.25 V

Manifold absolute pressure sensor (Apply Vacuum and Pressure) 
Applied Vacuum
Condition
Specified Condition
13.3 kPa (100 mmHg, 3.94 in. Hg)
Decrease
0.3 to 0.5 V
26.7 kPa (200 mmHg, 7.84 in. Hg)
0.6 to 0.8 V
40.0 kPa (300 mmHg, 11.81 in. Hg)
0.95 to 1.15 V
19.6 kPa (0.20 kgf/cm2, 2.84 psi)
Increase
0.4 to 0.7 V
39.2 kPa (0.40 kgf/cm2, 5.69 psi)
0.9 to 1.2 V
58.8 kPa (0.60 kgf/cm2, 8.53 psi)
1.5 to 1.8 V
78.5 kPa (0.80 kgf/cm2, 11.4 psi)
2.0 to 2.3 V
98.0 kPa (1.00kgf/cm2, 14.2 psi)
2.5 to 2.8 V

Accelerator pedal rod 
Tester Connection
Condition
Specified Condition
Intelligent tester to DLC3
Ignition switch ON
0.6 to 1.0 V