AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Data Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the R32 radio and display receiver assembly connector.
Disconnect the N5 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R32-2 (US1-) - N5-2 (US1-) | Always | Below 1 Ω |
| R32-3 (US1+) - N5-3 (US1+) | Always | Below 1 Ω |
| R32-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| R32-3 (US1+) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||