2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE STARTER YOKE ASSEMBLY

  1. A223813
    Remove the nut and disconnect the lead wire from terminal C.

  1. Remove the 2 bolts.

  1. Pull out the starter yoke and starter commutator end frame together with the starter armature.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A223814
    Remove the 2 screws and magnet starter switch.

  1. Remove the idle gear, retainer, clutch roller, return spring and starter clutch from the starter drive housing.

    A223815E01

  1. A115020E02
    Using a magnet hand, remove the steel ball from the starter clutch hole.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A223816
    Remove the 2 screws and commutator end frame from the starter yoke.

    NOTICE:
    While holding down the lead wire, remove the starter commutator end frame.

  1. Remove the dust protector from the commutator end frame.

  1. Remove the O-ring from the starter yoke.

  1. A215926
    Disconnect the 4 brushes from the starter brush holder.

    1. Using a screwdriver, hold back the spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the brush holder.


4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.

← REMOVAL (from Aug 2013)INSPECTION (from Jun 2011) →