2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

NOTICE:
  1. When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
  2. When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
  3. After removing the injection pipes, clean them with a brush and compressed air.
  4. Remove the glow plugs while they are still warm after completely warming up the engine.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
(Click here)

3. REMOVE GLOW CONNECTOR BRACKET

A253492
  1. Disconnect the No. 1 glow plug connector and detach the clamp.

  1. A254198
    Remove the bolt and glow connector bracket.


4. REMOVE NO. 2 MANIFOLD STAY

  1. A245458
    Remove the bolt and No. 2 manifold stay.


5. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Disconnect the No. 1 glow plug connector from the wire harness.

  1. A247184
    Remove the 4 screw grommets.

  1. A247185
    Remove the 4 nuts and No. 1 glow plug connector.


6. REMOVE NO. 1 INTAKE MANIFOLD INSULATOR

A256544

7. REMOVE GLOW PLUG

A222608
  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.

← REMOVAL (Aug 2012 – Jul 2013)INSTALLATION (Jun 2011 – Jul 2012) →