2014 Hilux · Service Manual BODY ELECTRICAL

No Sound can be Heard from Speakers

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

INSPECTION PROCEDURE


1. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
  1. Check the radio and display receiver assembly setting.

    1. Check that the volume is not set to "0".

      OK:
      The volume is not set to "0".



NG
SET VOLUME TO HIGH AND TURN MUTE OFF
OK


2. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
  1. In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

    OK:
    Audio system returns to normal.

    HINT:
    Sound quality adjustment measures vary according to the type of amplifier.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (AUDIO SETTINGS ARE DEFECTIVE)


← No Sound can be Heard from Speakers (Aug 2012 – Jul 2013)Sound Quality is Bad Only when CD is Played (Volume is Too Low) (Jun 2011 – Jul 2012) →