2014 Hilux · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jun 2011 – Oct 2011

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
Use these procedures to troubleshoot the audio and visual system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the ignition switch off.

    2. Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.BASIC INSPECTION
    1. Turn the ignition switch to ON.

    2. Check whether or not the radio receiver turns on.

      Result 
      Result
      Proceed to
      Radio receiver turns on
      A
      Radio receiver does not turn on
      B


    B.
    A

    4.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs.

    3. Recheck for DTCs by simulating the operation indicated by the DTCs.

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    5.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).

    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2011 – Jul 2012) →