DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1.
REMOVE MAGNET STARTER SWITCH ASSEMBLY |
 |
- Remove the nut, and then disconnect the lead wire from terminal C.
- Using a T25 "TORX" socket wrench, remove the 3 screws holding the magnet starter switch to the starter drive housing.
Remove the magnet starter switch.
Remove the return spring.
- Remove the plunger from the pinion drive lever.
| 2.
REMOVE STARTER YOKE ASSEMBLY |
 |
- Remove the 2 bolts and starter yoke from the starter drive housing.
- Remove the plate from the planet carrier.
| 3.
REMOVE STARTER BRUSH HOLDER ASSEMBLY |
 |
- Hold the starter yoke assembly between aluminum plates in a vise.
- NOTICE:
- Do not damage the starter yoke assembly.
Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.
- Remove the slotted washer.
- Remove the washer.
Remove the starter commutator end frame from the starter yoke.
- Remove the starter brush holder from the starter armature.
- NOTICE:
- Do not pull on the rubber part.
| 4.
REMOVE STARTER ARMATURE ASSEMBLY |
 |
- Remove the starter armature from the starter yoke.
| 5.
REMOVE STARTER CLUTCH SUB-ASSEMBLY |
 |
- Remove the 3 planetary gears from the planet carrier.
- Remove the starter center bearing clutch, pinion drive lever and cover from the starter drive housing.
- Using a screwdriver, move the pinion stop collar to the starter clutch.
- Using a screwdriver, remove the snap ring.
- Remove the pinion stop collar and starter clutch from the planet carrier shaft.
| 6.
REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY |
 |
- Using 2 screwdrivers and a hammer, tap off the snap ring from the planet carrier shaft.
Remove the washer from the planet carrier shaft.
- Remove the planet carrier shaft from the planet carrier.
Remove the intermediate sealing and the 3 damper rubbers from the planet carrier.