2014 Hilux · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE INSTRUMENT PANEL DOOR (w/o Front Passenger Airbag)
  1. Remove the 2 screws <B>.

  1. Detach the 8 claws and 2 guides and remove the instrument panel door.

    B278233


2. REMOVE NO. 1 DEFROSTER NOZZLE OPENING PLATE (w/o Defroster)

B278234
  1. Detach the 6 claws and remove the No. 1 defroster nozzle opening plate.


3. REMOVE NO. 2 DEFROSTER NOZZLE OPENING PLATE (w/o Defroster)

HINT:
Use the same procedure described for the No. 1 defroster nozzle opening plate.


4. REMOVE METER MOUNTING BRACKET

B278235
  1. Remove the screw <B> and meter mounting bracket.


5. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

B206170
  1. Detach the 4 claws and remove the No. 2 instrument panel register.


6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

HINT:
Use the same procedure described for the No. 2 instrument panel register.


7. REMOVE INSTRUMENT PANEL CUP HOLDER SUB-ASSEMBLY

B206171

HINT:
Use the same procedure for both instrument panel cup holders.

  1. Remove the 3 screws <B> and instrument panel cup holder.


8. REMOVE NO. 4 INSTRUMENT PANEL CUSHION

B206458
  1. Remove the No. 4 instrument panel cushion.


9. REMOVE NO. 3 INSTRUMENT PANEL CUSHION

B206460
  1. Remove the No. 3 instrument panel cushion.


10. REMOVE NO. 2 INSTRUMENT PANEL CUSHION

B278067
  1. Remove the No. 2 instrument panel cushion.


11. REMOVE AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)

  1. E229142
    Detach the 2 claws and remove the automatic light control sensor.


12. REMOVE LIGHT CONTROL SWITCH HOLE COVER (w/ Automatic Light Control System)

B277375
  1. Detach the 2 claws and guide and remove the light control switch hole cover.


13. INSTALL COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)

E226877E01
  1. Put protective tape around the cooler thermistor (solar sensor).

  1. Using a screwdriver, detach the 2 claws and remove the cooler thermistor (solar sensor).

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connector.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Cooler Thermistor (Solar Sensor)

← DISASSEMBLY (Jun 2011 – Jul 2012)DISASSEMBLY (from Aug 2013) →