2014 Hilux · Service Manual CRUISE CONTROL SYSTEM

ROAD TEST

Troubleshooting · Vehicles built from Jun 2011


PROBLEM SYMPTOM CONFIRMATION

  1. E107085
    Inspect the SET function.

    1. Turn the cruise control main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. After releasing the switch, check that the vehicle cruises at the set speed.

  2. E107086
    Inspect the + (ACCELERATION) function.

    1. Turn the cruise control main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. Check that the vehicle speed increases while the cruise control main switch is pushed to +RES, and that the vehicle cruises at the newly set speed when the switch is released.

    5. Momentarily (approximately 0.6 seconds) push the cruise control main switch to +RES and then immediately release it. Check that the vehicle speed increases by approximately 1.6 km/h (1.0 mph) (TAP-UP control).

  3. E107085
    Inspect the - (COAST) function.

    1. Turn the cruise control main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. Check that the vehicle speed decreases while the cruise control main switch is pushed to -SET, and that the vehicle cruises at the newly set speed when the switch is released.

    5. Momentarily (approximately 0.6 seconds) push the cruise control main switch to -SET, and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (TAP-DOWN control).

  4. E107087
    Inspect the CANCEL function.

    1. Turn the cruise control main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is restored.

      1. Depressing the brake pedal.
      2. Shifting into any position except D or 3*1.
      3. Shifting into any position except D or 4*2.
      4. Turning the main switch off.
      5. Pulling the cruise control main switch to CANCEL.
      6. Depressing the clutch pedal*3.
      7. Driving the vehicle while the VSC system is operating*4.
      1. *1: for A340F Automatic Transmission
      2. *2: for A750E, A750F Automatic Transmission
      3. *3: for Manual Transmission
      4. *4: w/ VSC

  5. E107086
    Inspect the RES (RESUME) function.

    1. Turn the cruise control main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. Cancel the cruise control system by performing one of the cruise control system cancel operations described above (other than turning the cruise control main switch off).

    5. After pushing the cruise control main switch to +RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle drives at the set speed.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2013)PROBLEM SYMPTOMS TABLE (Jun 2011 – Jul 2012) →