P0504 Brake Switch "A" / "B" Correlation
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
In this system, the signal of the stop light switch is used to judge whether the acceleration system is abnormal or not.The stop light switch has a duplex system (signals STP and ST1-) to memorize the abnormality when the signals of depressing and releasing the brake pedal are detected simultaneously.
- HINT:
- The Normal condition is shown in the table below.
| Signal |
Brake Pedal Released |
In Transition |
Brake Pedal Depressed |
| STP |
OFF |
ON |
ON |
| ST1- |
ON |
ON |
OFF |
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0504 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Reed freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. CHECK OPERATION OF STOP LIGHT |
Check if the stop lights illuminate and turn off normally when the brake pedal is depressed and released.
- OK:
- Stop lights illuminate and turn off.
|
|
||||
| OK | |
| 2. INSPECT STOP LIGHT SWITCH |
![]() ![]() |
Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Switch pin not pushed
Below 1 Ω
3 - 4
Switch pin not pushed
10 kΩ or higher
1 - 2
Switch pin pushed
10 kΩ or higher
3 - 4
Switch pin pushed
Below 1 Ω
|
|
||||
| OK | |
| 3. READ DATA LIST (STP SIGNAL AND ST1 - VOLTAGE) |
![]() ![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Stop Light SW.
Check the result.
- Standard:
Brake Pedal
Specified Condition
Depressed
STP Signal ON
Released
STP Signal OFF
Measure the voltage of the E14 and E17 ECM connectors.
- Standard voltage:
Tester Connection
Brake Pedal
Specified Condition
E14-16 (ST1-) - E17-1 (E1)
Depressed
Below 1.5 V
E14-16 (ST1-) - E17-1 (E1)
Released
7.5 to 14 V
|
|
||||
| NG | |
| 4. CHECK WIRE HARNESS (STOP LIGHT SWITCH - ECM) |
![]() ![]() |
Disconnect the S14 stop light switch connector.
Disconnect the E14 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
S14-1 - E14-15 (STP)
Below 1 Ω
S14-4 - E14-16 (ST1-)
Below 1 Ω
S14-1 or E14-15 (STP) - Body ground
10 kΩ or higher
S14-4 or E14-16 (ST1-) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||



