P0560 System Voltage
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
The battery supplies power to terminal BATT of the ECM even when the ignition switch is OFF. This power allows the ECM to store DTC history, freeze frame data, fuel trim values, and other data.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0560 |
Open in backup power source circuit |
|
- HINT:
- If DTC P0560 is set, the ECM does not store other DTCs.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. CHECK FUSE (EFI) |
![]() ![]() |
Remove the EFI fuse from the engine room junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK ECM (BATT VOLTAGE) |
![]() ![]() |
Measure the voltage of the ECM connectors.
- Standard voltage:
Tester Connection
Specified Condition
E9-3 (BATT) - E12-3 (E1)
9 to 14 V
|
|
||||
| NG | |
| 3. CHECK WIRE HARNESS (EFI FUSE - ECM AND BATTERY) |
![]() ![]() |
Remove the EFI fuse from the engine room junction block.
Disconnect the E9 ECM connector.
Disconnect the cable from the positive (+) battery terminal.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
J/B EFI fuse terminal 2 - E9-3 (BATT)
Below 1 Ω
Positive (+) battery cable terminal - J/B EFI fuse terminal 1
Below 1 Ω
J/B EFI fuse terminal 2 or E9-3 (BATT) - Body ground
10 kΩ or higher
Positive (+) battery cable terminal or J/B EFI fuse terminal 1 - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT BATTERY |
Check that the battery is not depleted.
- OK:
- Battery is not depleted.
|
|
||||
| OK | ||
| ||



