2014 Hilux · Service Manual TRANSMISSION

P0560 System Voltage

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

The battery supplies power to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the TCM will illuminate the MIL and store the DTC.
DTC Code
DTC Detection Condition
Trouble Area
P0560
Open in the TCM back-up power source circuit (1 trip detection logic).
  1. Open in back-up power source circuit
  2. TCM

HINT:
If DTC P0560 is stored, the TCM does not store other DTCs.


WIRING DIAGRAM

C156221E04

INSPECTION PROCEDURE


1. CHECK TCM (BATTERY, GROUND)

  1. C193057E04
    Disconnect the T38 and T19 TCM connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T38-5 (BATT) - T19-1 (E1)
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, GROUND)
OK

REPLACE TCM


← P0500 Vehicle Speed Sensor Malfunction (from Jun 2011)P0617 Starter Relay Circuit High (Jun 2011 – Jul 2012) →