2014 Hilux · Service Manual TRANSMISSION

P0560/96 System Voltage

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

The battery supplies power to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the TCM will illuminate the MIL and store the DTC.
DTC No.
DTC Detection Condition
Trouble Area
P0560/96
Open in the TCM back-up power source circuit (1 trip detection logic).
  1. Open in back-up power source circuit
  2. TCM

HINT:
If DTC P0560/96 is stored, the TCM does not store other DTCs.


WIRING DIAGRAM

C156221E05

INSPECTION PROCEDURE


1. CHECK TCM (BATTERY, GROUND)

  1. C193057E05
    Disconnect the T38 and T19 TCM connectors.

  1. Measure the voltage of the wire harness side connectors.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T38-5 (BATT) - T19-1 (E1)
    Always
    11 to 14 V

  1. Measure the resistance of the wire harness side connector.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, GROUND)
OK

REPLACE TCM


← P0500/42 Vehicle Speed Sensor Malfunction (from Jun 2011)P0705/C2 Transmission Range Sensor Circuit Malfunction (PRNDL Input) (Jun 2011 – Jul 2012) →