2014 Hilux · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE VACUUM PUMP PULLEY

  1. C106117
    Using soft jaws, place the vacuum pump in a vise, and remove the pulley lock nut and pulley.


2. REMOVE VACUUM PUMP VACUUM HOSE UNION

  1. F043196E01
    Using SST, hold the check valve assembly, and remove the union bolt, vacuum hose union and 2 gaskets.
    SST
    09922-10010  


3. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

  1. F043197
    Remove the check valve assembly and gasket.


4. REMOVE VACUUM PUMP END COVER

  1. F000813
    Remove the 4 screws and end cover.


5. REMOVE VACUUM PUMP SHAFT

  1. F000814
    Using a plastic-faced hammer, tap out the vacuum pump shaft with bearing.


6. REMOVE STOP RING
  1. Remove the stop ring from the vacuum pump shaft.


7. REMOVE VACUUM PUMP BEARING

  1. F000815
    Using a press, press out the bearing from the rotor shaft.


8. REMOVE VACUUM PUMP BLADE

  1. F043221
    Remove the 2 screws and end plate.

  1. Remove the rotor and 5 pump blades.


9. REMOVE O-RING
  1. Remove the O-ring from the case.


10. REMOVE OIL SEAL

  1. F000816
    Using a screwdriver, remove the oil seal.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →