2014 Hilux · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL OIL SEAL

  1. F000817E01
    Using SST and a hammer, tap in the oil seal.
    SST
    09950-60010   (09951-00400)
    09950-70010   (09951-07150)


2. INSTALL O-RING
  1. Apply engine oil on a new O-ring and install the O-ring to the vacuum pump case.


3. INSTALL VACUUM PUMP BEARING

  1. F043198
    Using a press, press in a new bearing to the pump shaft.


4. INSTALL VACUUM PUMP SHAFT
  1. Install the vacuum pump shaft and stop ring to the vacuum pump case.


5. INSTALL VACUUM PUMP BLADE

  1. F043199
    Apply engine oil to the rotor and 5 new vacuum pump blades.

  1. Install the rotor and pump blades with the round end facing outward.

  1. F043221
    Install the end plate with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 17 in.*lbf }


6. INSTALL VACUUM PUMP END COVER

  1. F000813
    Install the end cover with the 4 screws.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


7. INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY

  1. F043197
    Using soft jaws, place the vacuum pump in a vise. Then install a new gasket and check valve.

    Torque:
    74 N*m{ 755 kgf*cm , 54 ft.*lbf }


8. INSTALL VACUUM PUMP VACUUM HOSE UNION

  1. F043220E01
    Using SST, hold the check valve, and install 2 new gaskets and the vacuum hose union with the union bolt.
    SST
    09922-10010  

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }


9. INSTALL VACUUM PUMP PULLEY

  1. C106117
    Install the vacuum pump pulley with the pulley lock nut.

    Torque:
    105 N*m{ 1,075 kgf*cm , 78 ft.*lbf }

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →