2014 Hilux · Service Manual ENGINE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

NOTICE:
Intelligent tester only:
  1. When the diagnosis system is changed from normal mode to check mode, or vice versa, all the DTCs and freeze frame data recorded in normal mode are erased. Before changing modes, always check and make a note of any DTCs and freeze frame data.


CHECK DTC (using the intelligent tester)

  1. A099015E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON and turn the tester ON.

  3. A090409E01
    Enter the following menus: Powertrain / Engine and ECT / DTC.

  4. Check the DTC(s) and freeze frame data, and then write them down.

  5. Confirm the details of the DTCs (Click here).


CHECK DTC (not using the intelligent tester)

  1. A082779E07
    Turn the ignition switch ON.

  2. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

    SST
    09843-18040  

  3. A073556E01
    Read DTCs by observing the MIL. If no DTC is detected, the MIL blinks as shown in the illustration.

  4. A110552E02
    Example

    1. DTCs 12 and 31 (2) are detected and the MIL starts displaying the DTCs as shown in the illustration. The MIL blinking pattern of DTC 12 will be displayed first.

    2. A 2.5 second pause will occur. This pause will occur between the MIL blinking patterns of each DTC.

    3. The MIL blinking pattern of DTC 31 will be displayed.

    4. A 4.5 second pause will occur. This pause will occur when the MIL blinking pattern is the last of a string of multiple DTCs.

    5. The MIL will repeat the display of the string of DTCs again.

  5. Check the details of the malfunction using the DTC chart (Click here).

  6. After completing the check, disconnect terminals 13 (TC) and 4 (CG) and turn off the display.

    HINT:
    If 2 or more DTCs are detected, the MIL will display the lowest numbered DTC first.

  7. Confirm the details of the DTCs (Click here).


CLEAR DTCS AND FREEZE FRAME DATA (using the intelligent tester)

  1. A090410E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON (do not start the engine) and turn the tester ON.

  3. Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

  4. Erase DTCs and freeze frame data by pressing the YES button on the tester.


CLEAR DTCS AND FREEZE FRAME DATA (not using the intelligent tester)

  1. A121707E01
    Perform either one of the following operations.

    1. Remove the EFI fuse from the engine room junction block located inside the engine compartment for more than 1 minute.

    2. Disconnect the battery negative cable for more than 1 minute.

      NOTICE:
      1. After reconnecting the battery cable, the radio and clock should be adjusted as they were previously.
      2. After reconnecting the battery cable, perform the initialization procedure.

← DTC CHECK / CLEAR (Aug 2013 – Jul 2014)CHECK MODE PROCEDURE (Jun 2011 – Oct 2011) →