2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL NO. 1 ECM BRACKET
  1. Install the No. 1 ECM bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL ECM
  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 4 connectors.


4. INSTALL 4WD CONTROL ECU (for 4WD)
  1. Install the 4WD control ECU with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.


5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

B278068E01
  1. Attach the 2 hinges to install the glove compartment door.

    Text in Illustration 
    *1
    Hinge

  1. B278069E01
    While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
    Text in Illustration 
    *1
    Stopper


6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Only perform registration when the ECM is replaced, either by itself or in any of the following combinations.
    1. ECM and Diesel Throttle Body Assembly

← INSTALLATION (Aug 2012 – Jul 2013)COMPONENTS (Jun 2011 – Jul 2013) →