2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.

  1. Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A112146E01


3. REMOVE INTAKE AIR CONNECTOR
  1. Disconnect the vacuum hose.

  1. Disconnect the No. 2 ventilation hose.

  1. Loosen the hose clamp, and remove the 2 bolts and intake air connector.


4. REMOVE STARTER ASSEMBLY

  1. G039103E03
    Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.

  1. Remove the 2 bolts and starter.


5. REMOVE THROTTLE BODY
  1. Disconnect the throttle position sensor and control motor connector.

  1. Disconnect the 2 water by-pass hoses.

  1. A086829E01
    Remove the 2 bolts, 2 nuts and throttle body.

  1. Remove the gasket.


6. REMOVE INTAKE MANIFOLD

  1. G039042E03
    Disconnect the vacuum hose.

  1. Disconnect the VSV hose and connector for EVAP.

  1. Remove the 5 bolts, 2 nuts, intake manifold and gasket.


7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

  1. A111697
    Disconnect the sensor connector.

  1. Remove the sensor.

  1. Remove the gasket from the sensor.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →