REMOVAL
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. DRAIN ENGINE COOLANT |
Remove the radiator cap.
Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.


| 3. REMOVE INTAKE AIR CONNECTOR |
Disconnect the vacuum hose.
Disconnect the No. 2 ventilation hose.
Loosen the hose clamp, and remove the 2 bolts and intake air connector.
| 4. REMOVE STARTER ASSEMBLY |
Disconnect the starter connector.

Disconnect the terminal cap.
Remove the nut and disconnect the starter wire.
Remove the 2 bolts and starter.
| 5. REMOVE THROTTLE BODY |
Disconnect the throttle position sensor and control motor connector.
Disconnect the 2 water by-pass hoses.
Remove the 4 bolts and throttle body.

Remove the gasket.
| 6. REMOVE INTAKE MANIFOLD |
Disconnect the vacuum hose.

Disconnect the VSV hose and connector for EVAP.
Remove the 5 bolts, 2 nuts, intake manifold and gasket.
| 7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
Disconnect the sensor connector.

Remove the sensor.
Remove the gasket from the sensor.
