REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE ACCELERATOR PEDAL ROD |
- NOTICE:
- Avoid excessive force to the accelerator pedal sensor.
- Do not disassemble the accelerator pedal sensor assembly.
- This accelerator pedal does not require lubrication.
Do not apply oil or lubricant to the accelerator pedal sensor assembly.
If applied, the accelerator pedal rod assembly must be replaced.
- Avoid excessive force to the accelerator pedal sensor.
Disconnect the accelerator pedal position sensor connector.

Remove the 2 bolts and accelerator pedal rod.
