2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK THROTTLE BODY

  1. A075905
    Check the throttle control motor operating sound.

    1. Turn the ignition switch ON.

    2. When pressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises emit from the motor.
      If friction noise is heard, replace the throttle body.

  1. A099015E01
    Check the throttle position sensor.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON.

    3. Under Current Data, check that the throttle valve opening percentage (Throttle Pos) is within the standard.

      Standard throttle valve opening percentage:
      60% or more

      NOTICE:
      When checking the standard throttle valve opening percentage, the shift lever should be in the N position.

      If the percentage is less than 60%, replace the throttle body.

  1. Inspect the air assist system.

    1. Start the engine and check that the check engine (CHK ENG) warning light does not illuminate.

    2. Warm up the engine to the normal operating temperature.

    3. Turn the A/C compressor from ON to OFF and check the idle speed.

      Standard idle speed (with the gear position is neutral):
      700 +- 50 rpm

      NOTICE:
      Perform this inspection without any electrical load on the vehicle.

← COMPONENTS (from Jun 2011)REMOVAL (Jun 2011 – Jul 2012) →