2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE DRIVE BELT

  1. A099194E01
    Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


3. REMOVE COOLER COMPRESSOR ASSEMBLY

  1. A099198E02
    Remove the 2 bolts and disconnect the suction hose from the engine.

  1. G039332E03
    Disconnect the cooler compressor connector.

  1. Remove the 4 bolts and disconnect the compressor from the engine.

  1. Support the cooler compressor securely.


4. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

  1. A099203E02
    Remove the 5 bolts and No. 1 compressor mounting bracket.


5. REMOVE CRANKSHAFT POSITION SENSOR

  1. A099147E04
    Disconnect the sensor connector.

  1. Disconnect the connector from the connector bracket.

  1. Detach the harness clamp.

  1. Remove the bolt and sensor.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →