Removal / installation · Vehicles built from Jun 2011
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.
REMOVE DRIVE BELT
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.
NOTICE:
When removing the drive belt, do not use the idle pulley's bolt.
HINT:
After removing the drive belt, move the tensioner upward to the maximum amount.
3.
REMOVE COOLER COMPRESSOR ASSEMBLY
Remove the 2 bolts and disconnect the suction hose from the engine.
Disconnect the cooler compressor connector.
Remove the 4 bolts and disconnect the compressor from the engine.
Support the cooler compressor securely.
4.
REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 5 bolts and No. 1 compressor mounting bracket.
5.
REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the sensor connector.
Disconnect the connector from the connector bracket.