DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| DESCRIPTION |
The Malfunction Indicator Lamp (MIL) illuminates when the vehicle's on-board computer detects a malfunction in the computer itself or in drive system components. In addition, the applicable Diagnostic Trouble Codes (DTCs) are recorded in the ECM memory (Click here).
If the malfunction does not reoccur, the MIL stays illuminated until the ignition switch is turned OFF, and then the MIL turns OFF when the ignition switch is turned ON. However the DTCs remain recorded in the ECM memory.
To check DTCs, connect the tester to the Data Link Connector 3 (DLC3) on the vehicle or connect terminals TC and CG on the DLC3 (DTCs will be displayed on the combination meter).
![]() ![]() ![]() ![]() |
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
| FREEZE FRAME DATA |
The tester records freeze frame data in five different instances: 1) 3 times before the DTC is set, 2) once when the DTC is set, and 3) once after the DTC is set. These data can be used to simulate the vehicle's condition around the time when the malfunction occurred. The data may help find the cause of the malfunction, or help in judging if the DTC is being caused by a temporary malfunction or not.
![]() ![]() |
| CHECK MIL |
![]() ![]() |
The MIL illuminates when the ignition switch is turned ON and the engine is not running.
- HINT:
- If the MIL is not illuminated, check the MIL circuit (Click here).
When the engine is started, check that the MIL turns OFF.
If the lamp remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.




