2014 Hilux · Service Manual TRANSMISSION

HYDRAULIC TEST

Troubleshooting · Vehicles built from Jun 2011


MEASURE LINE PRESSURE
C159068E01

NOTICE:
  1. Perform the test at the normal operating ATF temperature: 50 to 80°C (122 to 176°F).
  2. The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels or wheel chocks while the other is performing the test.
  3. Be careful to prevent SST's hose from interfering with the exhaust pipe.
  4. This test must be performed after checking and adjusting the engine.
  5. Perform the test with the A/C OFF.
  6. When conducting the stall test, do not continue more than 5 seconds.

  1. Warm up the ATF.

  2. Remove the test plug on the transmission case center right side and connect SST.

    SST
    09992-00095   (09992-00231, 09992-00271)

  3. Fully apply the parking brake and chock the 4 wheels.

  4. Start the engine and check idling speed.

  5. Keep your left foot firmly on the brake pedal and move the shift lever to D.

  6. Measure the line pressure when the engine is idling.

  7. Depress the accelerator pedal as much a possible. Quickly read the highest line pressure reading when the engine speed reaches stall speed.

  8. Perform the measure line pressure test again with the shift lever on R.

    Specified line pressure: 
    Condition
    Shift Lever on D
    Shift Lever on R
    Stall
    1200 to 1450 kPa
    (12.2 to 14.8 kgf/cm2, 174 to 210 psi)
    1150 to 1450 kPa
    (11.7 to 14.8 kgf/cm2, 167 to 210 psi)
    Evaluation: 
    Problem
    Possible Cause
    Measured values at all positions are higher than specified
    1. Shift solenoid valve SLT defective
    2. Regulator valve defective
    Measured values at all positions are lower than specified
    1. Shift solenoid valve SLT defective
    2. Regulator valve defective
    3. Oil pump defective
    Pressure is low when shift lever is on D only
    1. D position circuit fluid leak
    2. C1 clutch defective
    Pressure is low when shift lever is on R only
    1. R position circuit fluid leak
    2. C3 clutch defective
    3. B4 brake defective

← MECHANICAL SYSTEM TESTS (from Jun 2011)MANUAL SHIFTING TEST (Jun 2011 – Jul 2012) →