MANUAL SHIFTING TEST
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Jun 2011 – Jul 2014 from Aug 2014
| MANUAL SHIFTING TEST |
- HINT:
- Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.
- If any abnormalities are found in the following test, the problem is in the transmission itself.
- Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.
Disconnect the connector of the transmission wire.

- HINT:
- It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gear positions can then be changed mechanically with the shift lever.
Drive with the transmission wire disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.
Shift Lever Position
Gear Position
D
4th
2
3rd
L
1st
R
R
P
P
Connect the connector of the transmission wire.
Clear the DTC (Click here).