2014 Hilux · Service Manual TRANSMISSION

INITIALIZATION

Troubleshooting · Vehicles built from Jun 2011


RESET MEMORY

NOTICE:
  1. Perform the Reset Memory (AT initialization) when replacing the automatic transmission assembly, valve body assembly or any of the shift solenoid valves.
  2. The Reset Memory can be performed only with the intelligent tester.

HINT:
The TCM memorizes the control conditions of the automatic transmission assembly and engine assembly. Therefore, when the automatic transmission assembly, valve body assembly or any of the shift solenoid valves has been replaced, it is necessary to reset the memory so that the TCM can memorize the new information.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Powertrain / ECT / Utility / Reset Memory.

    NOTICE:
    After performing the Reset Memory, be sure to perform the Road Test (Click here) described earlier.

    HINT:
    The TCM learns through the road test.

← MANUAL SHIFTING TEST (from Aug 2012)MONITOR DRIVE PATTERN (Jun 2011 – Jul 2012) →