P0724 Brake Switch "B" Circuit High
Diagnostic trouble codes · Vehicles built from Aug 2012
DESCRIPTION
The purpose of this circuit is to prevent the engine from stalling while driving in the lock-up condition when the brakes are suddenly applied.When the brake pedal is depressed, this switch sends a signal to the TCM. Then the TCM cancels the operation of the lock-up clutch while braking is in progress.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0724 |
Stop light switch remains on even when the vehicle is driven in a stop (less than 3 km/h (2 mph)) and go (30 km/h (19 mph) or more) pattern 5 times (2-trip detection logic). |
|
MONITOR DESCRIPTION
This DTC indicates that the stop light switch remains on. When the stop light switch remains on during stop and go driving, the TCM interprets this as a fault in the stop light switch. Then the MIL illuminates and the TCM stores the DTC. The vehicle must stop (less than 3 km/h (2 mph)) and go (30 km/h (19 mph) or more) 5 times for 2 driving cycles in order for the DTC to be stored.WIRING DIAGRAM


INSPECTION PROCEDURE
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the intelligent tester, read the Data List.
ECT Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Stop Light Switch
Stop light switch status/
ON or OFF
- Brake pedal is depressed: ON
- Brake pedal is released: OFF
-
- Brake pedal is depressed: ON
| 1. INSPECT STOP LIGHT SWITCH ASSEMBLY |
Remove the stop light switch assembly (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pin not pushed
Below 1 Ω
3 - 4
Pin pushed
Below 1 Ω
1 - 2
Pin pushed
10 kΩ or higher
3 - 4
Pin not pushed
10 kΩ or higher
Text in Illustration *1
Pin
*a
Component without harness connected
(Stop Light Switch Assembly)
*b
Not pushed
*c
Pushed
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (BATTERY - TCM) |
Disconnect the TCM connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
T38-14 (STP) - Body ground
Brake pedal depressed
7.5 to 14 V
T38-14 (STP) - Body ground
Brake pedal released
Below 1 V
Text in Illustration *a
Front view of wire harness connector
(to TCM)
|
|
||||
| OK | ||
| ||
