2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


REMOVE STARTER RELAY (Marking: ST)
  1. Remove the engine room relay block cover.

  1. Remove the starter relay from the engine room relay block.


INSPECT STARTER RELAY

  1. B060778E26
    Inspect the starter relay resistance.

    Standard resistance:
    Terminal Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.


INSTALL STARTER RELAY

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

← ON-VEHICLE INSPECTION (Aug 2012 – Jul 2013)COMPONENTS (from Jun 2011) →