ON-VEHICLE INSPECTION
Inspection · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| INSPECT FUEL PUMP RELAY (Marking: F/PMP) |
![]() ![]() |
Remove the engine room relay block cover.
Remove the fuel pump from the engine room junction block.
Measure the fuel pump relay resistance.
- Standard resistance:
Tester Connection
Specified Condition
3 - 4
Below 1 Ω
3 - 5
10 kΩ or higher
3 - 4
10 kΩ or higher
(when battery voltage applied to terminals 1 and 2)
3 - 5
Below 1 Ω
(when battery voltage applied to terminals 1 and 2)
Reinstall the fuel pump relay to the engine room junction block.
Reinstall the engine room relay block cover.
| CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| PERFORM INITIALIZATION |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.


