The Malfunction Indicator Lamp (MIL) is used to indicate malfunction detections by the ECM. By turning the ignition switch ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL. The MIL operation can be checked visually. When the ignition switch ON is first turned ON, the MIL should be illuminated and should then turn OFF. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the intelligent tester.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Troubleshoot each trouble symptom in accordance with the chart below.
MIL remains illuminated
Start inspection from step 1
MIL not illuminated
Start inspection from step 3
1. CHECK THAT MIL IS ILLUMINATED
Troubleshoot each trouble symptom in accordance with the chart below.