The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunction detections by the ECM. By turning the ignition switch ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL. The MIL operation can be checked visually: When the ignition switch is first turned ON, the MIL should be illuminated, and should then turn OFF when the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using an intelligent tester.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
1. CHECK THAT MIL IS ILLUMINATED
Perform troubleshooting in accordance with the chart below.