REMOVAL
Removal / installation · Vehicles built from Aug 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
DRAIN ENGINE COOLANT
|
 |
Remove the radiator cap.
Loosen the cylinder block drain cock plug and radiator drain plug, and then the coolant.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.


| 3.
REMOVE V-BANK COVER
|
 |
- Remove the 2 nuts and the V-bank cover.
| 4.
REMOVE NO. 2 VENTILATION HOSE
|
 |
| 5.
REMOVE AIR CLEANER ASSEMBLY
|
 |
- Disconnect the vacuum hose.
Disconnect the MAF meter connector.
Remove the 2 wire harness clamps.
- Loosen the 2 hose clamps.
Remove the 2 bolts and air cleaner.
| 6.
REMOVE VVT SENSOR (for Bank 1) |
 |
- Disconnect the sensor connector.
Remove the bolt and sensor.
| 7.
REMOVE VVT SENSOR (for Bank 2) |
 |
- Disconnect the No. 4 and No.5 water by-pass hoses.
Disconnect the sensor connector.
- Remove the bolt and sensor.