CHECK FOR INTERMITTENT PROBLEMS
Troubleshooting · Vehicles built from Jun 2011
| CHECK FOR INTERMITTENT PROBLEMS |
- HINT:
- A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the ECU Data List function of the intelligent tester.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruptions should be monitored.
- HINT:
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
- If Error is displayed, measure the resistance between the ECUs and sensors or between ECUs.
- Error remains displayed on the intelligent tester for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal.
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Speed Open
Front speed sensor RH open circuit detection / Error or Normal
Normal
-
FL Speed Open
Front speed sensor LH open circuit detection / Error or Normal
Normal
-
RR Speed Open
Rear speed sensor RH open circuit detection / Error or Normal
Normal
-
RL Speed Open
Rear speed sensor LH open circuit detection / Error or Normal
Normal
-
EFI Communication Open
EFI communication open circuit detection / Error or Normal
Normal
-
Yaw Rate Open
Yaw rate sensor open circuit detection / Error or Normal
Normal
-
Deceleration Open
Acceleration sensor open circuit detection / Error or Normal
Normal
-
Steering Open
Steering angle sensor open circuit detection / Error or Normal
Normal
-
Master Cylinder Open
Master cylinder pressure sensor open circuit detection / Error or Normal
Normal
-
IG Voltage Value Decreased
IG voltage value decrease detection / Error or Normal
Normal
-
IG Voltage Value Increased
IG voltage value increase detection / Error or Normal
Normal
-
FR Speed Sensor Voltage Open
Front speed sensor RH voltage open circuit detection / Error or Normal
Normal
-
FL Speed Sensor Voltage Open
Front speed sensor LH voltage open circuit detection / Error or Normal
Normal
-
RR Speed Sensor Voltage Open
Rear speed sensor RH voltage open circuit detection / Error or Normal
Normal
-
RL Speed Sensor Voltage Open
Rear speed sensor LH voltage open circuit detection / Error or Normal
Normal
-
M/C Pressure Sensor Noise
Master cylinder pressure sensor noise detection / Error or Normal
Normal
-
Brake Pedal Switch Open
Brake pedal load sensing switch open circuit detection / Error or Normal
Normal
-
Yaw Rate Sensor Voltage Open
Yaw rate sensor voltage open circuit detection / Error or Normal
Normal
-
EFI Communication Invalid
EFI communication invalid detection / Error or Normal
Normal
-
While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors, or between ECUs.
- OK:
- Normal display does not change.
- HINT:
- If the display changes, the connector and/or wire harness has caused a momentary interruption of the circuit. Repair or replace the connector and/or wire harness as one of them is faulty.