2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK RADIATOR CAP SUB-ASSEMBLY

  1. A110260
    Measure the valve opening pressure.

    1. If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean the part(s) with water and finger scouring.

    2. Check that 1, 2 or 3 is not deformed, cracked or swollen.

    3. Check that 3 and 4 are not stuck together.

    4. Apply engine coolant to 2 and 3 before using the radiator cap tester.

    5. When using the cap tester, tilt it more than 30 degrees.

    6. A085446E01
      Pump the cap tester several times, and check the maximum pressure*.

      Pumping speed:
      1 pump per second

      *: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Judgment Criterion:
      Item
      Specified Condition
      Standard value
      (for brand-new cap)
      93.3 to 122.7 kPa (0.95 to 1.25 kgf*cm2, 13.5 to 17.8 psi)
      Minimum standard value
      (after using cap)
      78.5 kPa (0.8 kgf*cm2, 11.4 psi)

      If the maximum pressure is less than the minimum standard value, replace the radiator cap sub-assembly.

← COMPONENTS (from Aug 2013)ON-VEHICLE CLEANING (from Jun 2011) →