2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK RADIATOR CAP SUB-ASSEMBLY

  1. A110260
    Measure the valve opening pressure.

    1. If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean the part(s) with water and finger scouring.

    2. Check that 1, 2 or 3 is not deformed, cracked or swollen.

    3. Check that 3 and 4 are not stuck together.

    4. Apply engine coolant to 2 and 3 before using a radiator cap tester.

    5. When using the cap tester, tilt it more than 30°.

    6. A085446E01
      Pump the cap tester several times, and check the maximum pressure*.

      Pumping speed:
      1 pump per second

      *: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Judgment criterion:
      Item
      Specified Condition
      Standard value
      (for brand-new cap)
      93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
      Minimum standard value
      (after using cap)
      78.5 kPa (0.8 kgf/cm2, 11.4 psi)

      If the maximum pressure is less than the minimum standard value, replace the radiator cap sub-assembly.

← COMPONENTS (from Jun 2011)ON-VEHICLE CLEANING (from Jun 2011) →