ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| CHECK ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipsticks low and full level marks.
If low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill with engine oil over the full level mark.
| CHECK ENGINE OIL QUALITY |
Check the oil for deterioration, water contamination, discoloring or thinning.
If the oil quality is visibly poor, replace the oil.


- Oil grade:
- 5W-30 and 10W-30:
API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil
15W-40 and 20W-50:
API grade SL, SM or SN multigrade engine oil
| REMOVE OIL PRESSURE SWITCH |
Disconnect the oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the oil pressure switch.
| INSTALL OIL PRESSURE GAUGE |
Install the oil pressure gauge.

| WARM UP ENGINE |
| CHECK OIL PRESSURE |
- Standard oil pressure:
Condition
Specified Condition
Idle
29 kPa (0.3 kgf/cm2, 4.2 psi) or more
3,000 rpm
294 to 588 kPa (3.0 to 6.0 kgf/cm2, 43 to 85 psi)
| INSTALL ENGINE OIL PRESSURE SWITCH |
Remove the oil pressure gauge.

Apply adhesive to 2 or 3 threads of the oil pressure switch.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Using a 24 mm deep socket wrench, Install the oil pressure switch.
- Torque:
- 15 N*m{ 152 kgf*cm , 11 ft.*lbf }
- NOTICE:
- Do not start the engine for 1 hour after the installation.
Connect the oil pressure switch connector.
| START ENGINE AND CHECK FOR LEAKS |
