Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.
Even after discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce risk of fuel spray on yourself or in the engine compartment.
Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Disconnect the fuel pump connector.
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.
HINT:
DTC P0171/25 (system too lean) may be set.
Crank the engine again, then check that the engine does not start.
Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.
Connect the fuel pump connector.
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Disconnect the throttle position sensor and control motor connector.
Disconnect the 2 water by-pass hoses.
Remove the 2 bolts, 2 nuts and throttle body.
Remove the gasket.
8.
REMOVE INTAKE MANIFOLD
Disconnect the crankshaft position sensor from the clamp.
Remove the 5 bolts, 2 nuts, intake manifold and gasket.
9.
REMOVE GENERATOR
Remove the nut, bolt and generator wire.
Disconnect the generator connector.
Remove the 2 bolts and generator.
10.
REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 5 bolts and No. 1 compressor mounting bracket.
11.
REMOVE V-RIBBED BELT TENSIONER
Remove the 3 bolts and belt tensioner.
12.
REMOVE WATER INLET
Remove the bolt, 2 nuts, water inlet and gasket.
13.
REMOVE THERMOSTAT
Remove the thermostat and gasket.
14.
REMOVE IDLER PULLEY
Remove the bolt, pulley plate, idler pulley and spacer.
15.
REMOVE NO. 1 WATER BY-PASS PIPE
Remove the 2 nuts, water by-pass pipe and gasket.
16.
REMOVE OIL FILLER CAP
17.
REMOVE CYLINDER HEAD COVER
Remove the 19 bolts, 2 nuts, head cover and 2 gaskets.
18.
REMOVE CAMSHAFT POSITION SENSOR
19.
REMOVE CRANKSHAFT PULLEY
Turn the crankshaft pulley, and align its groove with timing mark 0 of the timing chain cover.
Check that the timing marks of the camshaft timing gear and sprocket are aligned with the timing marks of the No. 1 bearing cap, as shown in the illustration.