2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


1. REMOVE DRIVE BELT

  1. A099194E01
    Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


2. REMOVE TENSIONER PULLEY

NOTICE:
Perform the following procedure when it is necessary to replace the tensioner pulley.

  1. Remove the oil dipstick.

  1. Remove the bolt, dipstick guide and O-ring.

    HINT:
    Cover the dipstick guide hole to prevent foreign matter from entering it.

  1. G035081E06
    Remove the bolt, dust seal, tensioner pulley and nut.

    NOTICE:
    Do not drop the nut.

← ON-VEHICLE INSPECTION (from Jun 2011)REMOVAL (from Aug 2012) →