2014 Hilux · Service Manual BODY ELECTRICAL

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Jun 2011


WIRELESS DOOR LOCK CONTROL SYSTEM DESCRIPTION
  1. This system locks and unlocks the vehicle's doors remotely. The wireless door lock control system has the following features:

    1. The door control receiver performs the code identification process and the driver side junction block assembly operates the door lock control. A serial data link is provided for communication between the door control receiver and driver side junction block assembly.
    2. A key-integrated type transmitter is used and it contains the following 2 switches: the door lock switch and door unlock switch.
    3. An LED is built into the transmitter so that the battery status can be checked.


FUNCTION OF MAIN COMPONENTS
Components
Functions
Door control transmitter assembly
  1. Contains lock and unlock switches.
  1. Transmits faint electric waves (recognition codes and function codes) to door control receiver.
  2. Illuminates indicator light (LED) during transmission.
Unlock warning switch assembly
Detects if key is in ignition key cylinder or not.
Front door courtesy light switch assembly LH/RH
Rear door courtesy light switch assembly LH/RH*1
  1. Located on each door.
  2. Turns on when the door is open and off when the door is closed. Outputs the door status (open or closed) to the driver side junction block assembly.
Front door lock assembly LH*2
Front door lock assembly RH*3
  1. Built-in motor locks and unlocks the door.
  2. Built-in door lock position switch detects the door status (locked or unlocked) and outputs a signal to the driver side junction block assembly. This switch turns off when the door is locked and turns on when the door is unlocked.
Front door lock assembly RH*2
Front door lock assembly LH*3
Rear door lock assembly LH/RH*1
Built-in motor locks and unlocks the door.
Door control receiver
Receives weak electric waves (recognition codes and function codes) from the driver side junction block assembly and changes the waves to code data.
  1. *1: for Double Cab
  2. *2: for LHD
  3. *3: for RHD

SYSTEM FUNCTION
  1. The wireless door lock control system has the following functions.

    Function
    Outline
    All door lock function
    Pressing lock switch locks all doors.
    All door unlock function
    1. Pressing the unlock switch once unlocks only the driver side door and pressing the unlock switch again within 3 seconds, unlock all the doors (for 2 Step Unlock Function).
    2. Pressing unlock switch unlocks all doors (except 2 Step Unlock Function).
    Answer-back function
    1. When the doors are locked by a wireless operation, the hazard warning lights and side turn signal lights flash once.
    2. When the doors are unlocked by a wireless operation, the hazard warning lights and side turn signal lights flash twice.
    Automatic locking function
    If no doors are opened within 30 seconds after they are unlocked by the door control transmitter assembly, all the doors lock again automatically.
    Illuminated entry function*
    1. All the doors are locked, pressing the unlock switch causes the key cylinder light assembly (ignition key cylinder light) to turn on and all the doors to unlock simultaneously.
    2. If the doors have not been opened, the key cylinder light assembly (ignition key cylinder light) turns off after approximately 15 seconds.
    Security function
    Sends signal as rolling code
    Transmitter recognition code registration function
    Enables 4 modes for registering (writing and storing) transmitter recognition codes in EEPROM, which is built into door control receiver
    1. *: w/ Illuminated Entry Function

← SYSTEM DIAGRAM (from Jun 2011)HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2011 – Jul 2013) →